Blaupunkt TBG601 Bedienungsanleitung Seite 7

TBG601
1. Body with the motor
2. Rotor
3. Jug
3a. Blade fixing nut
3b. Gasket
3c. Blade
4. Jug lid
5. Blender lid
BEFORE FIRST USE
1.Remove all paper, cardboard and film protecting the blender and its parts.
2.Clean the blender according to the instructions provided in the CLEANING AND MAINTENANCE
section.
TABLE BLENDER OPERATION
Place the jug (3) on the appliance's body (1) by fitting the rotor (2) into the blade assembly clutch at the
bottom of the jug. Put the ingredients into the jug. Pour some water. It is recommended not to fill the
jug with ingredients above ¾ of its capacity. Cover the jug with the lid (4).
Note: Hold the jug during the appliance's operation.
Insert the power cord plug into a power outlet.
Switch on the blender with the power switch by selecting the rotational speed with the knob (8).
For better mixing and grinding of ingredients, you can use a pusher to direct the ingredients towards
the blade.
Switch off the appliance when you obtain the required ingredients consistency. Do not switch on the
blender for more than 2 minutes. Wait 30 minutes before switching on the appliance again.
Unplug the appliance once you finished the operation.
APPLIANCE SAFETY FEATURES
The blender is equipped with the power switch lock and automatic switching off function in case the
operation conditions are not safe.
If the blender does not start or it switches off:
1. Ensure the jug lid is correctly fitted and turned to a position perpendicular to the handle.
2. Ensure the jug is correctly fitted on the rotor and turned so that the handle is perpendicular to the
control panel line.
3. The temperature or overload breaker could trip after the blender runs for too long or grinds very
hard ingredients. Wait 10-20 minutes for the blender to cool down and try to switch on the appliance
again.
CLEANING AND MAINTENANCE
Make sure the blender has been disconnected from the power supply.
Clean the body with a mildly damp cloth and then wipe it dry. Do not immerse the body in water or
other liquids.
After disassembly, all parts except for the body with the motor are suitable for cleaning with water
combined with a dishwashing liquid, or in a dishwasher.
You can unscrew the blade assembly from the jug for better cleaning.
6. Blender lid opening
7. Blender lid plug with a measuring cup
8. Power switch knob
8a. P – pulse mode
8b. 1 – lowest speed, 5 – highest speed
9. Pusher
10. Blade fixing nut gripper
5