Rebel MIE-RB10B Bedienungsanleitung Seite 14

Note:
• Take extra caution while measuring high
voltages.
• Frequency and duty cycle measurements are not
conducted while in DC voltage mode.
Resistance measurement
1. Set the rotary switch to
selecting the range, the default mode is resistance
measurement.
2. To switch between resistance, diode and
continuity measurement, press the SELECT
button.
Note:
• To avoid damaging the device while measuring
resistance, make sure that the circuit is
disconnected from the power. Capacitance
measurement may only be conducted after
discharging all of the capacitors.
• While measuring the resistance above 400 Ω,
test leads generate measuring error from 0,1 to
0,9. To get an accurate result, touch the red and
black test lead witch each other and subtract the
result from the measurement result. You can also
use the REL function.
• If the resistance is higher that MΩ, it may take a
while for the result to stabilize.
Continuity test
1. Set the rotary switch to
2. Press the SELECT button twice, and the
will appear.
3. Connect the test leads to the measured circuit.
EN
p o s i t i o n . A f t e r
position.
14
icon