Care And Maintenance - Westinghouse WKWK17802 Bedienungsanweisungen

3. Do not fill with less than 0.5 liters of water (to "min" indication) to prevent the
kettle running dry while operating.
4. Do not fill with more than 1.7 liters of water (to "max" indication).
5. An automatic safety cut-out has been fitted for protection against overheating,
it will operate if the kettle is switched on when containing insufficient water.
Always ensure the water inside the kettle covers the minimum mark on the
water level indicator gauge. If the automatic safety cut-out has operated,
switch the kettle off, disconnect from the power outlet and allow the kettle to
cool down for 5 to 10 minutes. The refill with and switch on, the kettle will work
as normal.
6. Place the power base on a dry, flat surface. Place the kettle on the power base.
7. Plug the cord set on the power base. The electrical connection will be made
automatically as the kettle slides onto the base.
8. Plug the cord set into an earthed power socket and switch on by pressing the
switch of the kettle to the "on" position.
9. When the water has boiled, the kettle will switch off automatically, after
allowing the kettle to cool down for 15-20 seconds, the water can be brought
back to the boil by pushing the switch back to the "on" position. During the
cooling down time do not force the on/off switch into the "on" position as this
can damage the operating mechanism.
NOTE:
• Do not remove the kettle from the power base without switching off first.
• The kettle may be switched off manually at any time by setting the on/off
switch into the "off" position.
• Ensure that the switch is free of obstructions and the lid is firmly closed, the
kettle will not turn off if the switch is constrained or if the lid is opened.

CARE AND MAINTENANCE

CAUTION:
• Never use solvents and abrasives, hard brushes, metallic or sharp objects for
cleaning. Solvents are harmful to health and attack the plastic parts. Abrasive
cleaners and tools scratch the surface.
• Never immerse the kettle, power cord or power base in water, or allow moisture
to contact with these parts.
CLEANING
1. Before cleaning the kettle, disconnect from the power supply and wait until it
was cooled down.
2. The kettle may be cleaned with a damp cloth.
Cleaning the filter
1. Empty the kettle and allow it to cool.
2. Make the spout toward users, you can see a tuber on the wall of housing, press
the tuber with a little force, and then lift the filter.
3. Rinse the filter under warm water and brush off any impurities.
4. To attach, make the tuber on the bottom of filter be supported by the flange
of spout, then push the filter towards the spout direction, the tuber on the top
of filter will lock the wall of housing.
EN
5