What To Do Before Calling For Authorized Service - Imbera IMB 250 CPY Bedienungsanleitung

WHAT TO DO BEFORE CALLING FOR AUTHORIZED SERVICE

Failure
If the cooler does not
operate (No noise or
just the fan noise)
Internal temperature of
the appliance is high
Internal temperature of
your appliance is very
low
Lamps of your cooler
does not illuminate or
only one lamp illumi-
nates.
Excessive perspiration
inside the appliance and
on the window.
Bad odours can be
smelt under your cooler.
Power ratings of the lamps or LEDs used in your products are
specified on the plate inside the cooler or in the installation area of the
lamps. Lamps and LEDs used in your products shall only be intervened
by Authorized Services.
32
Possible Solution
It may be caused by
the thermostat. It may
be unplugged. Fuse
may be blown or faulty.
Condenser fins may be
dirty or clogged.
Ambient temperature
is very high or thermo-
stat setting is incorrect.
Rear part is very close
to the wall, ventilation
blinds are blocked or its
front is covered. It may
be exposed to excessive
external wind. Condens-
er fins are very dirty
Wrong internal thermo-
stat setting
Lamps are turned off.
Lamp has burnt out or
the starter is faulty.
Water drainage hole
may be clogged for in-
ternal perspiration. Hu-
midity level of external
environment is higher
than 65% for perspira-
tion on the window.
Lower water drainage
tray is dirty. (Applies to
some models.)
Result
It shall operate again
when it reaches the
proper temperature.
Plug it correctly. Consult
authorized service or a
qualified electrician.
Take your cooler to a
place where ambient
temperature is lower.
Bring it to specified
clearance. Clean the
front of the ventilation
blinds. Prevent wind.
Clean the condenser
fins.
Reset the thermostat.
Turn the lamps on. Re-
place the faulty part.
Clean the water drain-
age hole. For high hu-
midity conditions, you
may place your cooler
in a location with less
humidity.
Clean the water drain-
age tray.