Installation - Imbera IMB 250 CPY Bedienungsanleitung

SECTION 4
LOCATION
Possible Installation Locations:
1- Ensure that a clearance of 150 mm (15 cm) is available between
the wall and your cooler so that solely the back of your cooler faces
the wall.
2- When you place it on the corner, leave a clearance of 150 mm (15
cm) on its back so that it faces the corner. You may lean the side on
the corner to the wall. (Figure 4)
The most important point for any kind of placement is that the venti-
lation of the compressor assembly is not blocked. Place your product
so that it is not inclined in any way and that it is standing on its legs
or castors and then operate it. (Figure 5)
Your appliance shall operate more efficiently when the ventilation of
the compressor assembly is better.

INSTALLATION

Take off and remove all package materials and lower wooden pallet of
your product before placing it. (It may be required to lift the cooler to
remove the base bracket).
Install spare parts provided inside your appliance as per the installa-
tion instructions. Use only genuine spare parts.
Picture 4 Picture 5
21