Thermostat Setting - Imbera IMB 250 CPY Bedienungsanleitung

ed. It the outlet that shall be used shall also be protected with a proper
fuse with a rating of 10-16 A minimum. Always get support from our
authorized service or a qualified electrician for the fuse that shall be
installed on the electrical installation where the outlet is connected.
(Figure 6)
The voltage and frequency of mains power should be the same as the
values specified on the label on the inner surface of your appliance. If
mains power is far below or above the specified value, have the desired
voltage by using a voltage regulator.
You can get help from a qualified electrician.
Do not put the cable of your product on passage routes. These may
cause injury to you and damage to your cooler.

THERMOSTAT SETTING

Temperature settings of your cooler is performed in our factory for
operation in suitable conditions.
Temperature for the preservation of the food is adjusted with the
thermostat by observing it from the thermometer on your cooler (op-
tional).
Internal temperature of your cooler may be adjusted by rotating the
thermostat switch. Position "7" on the thermostat shall decrease the
internal temperature to the minimum level. Internal temperature of
your product may be set between +1 and +9 C. (Figure 7)
Picture 6
23