Safety Instructions - Rebel Mie-Rb-33B Handbuch

SAFETY INSTRUCTIONS

In order to avoid electric shock or other injuries, follow the
safety instructions below:
1. Before using the device, inspect the case for any mechanical
damage. If the case has cracks or is missing any part, do not
use the device.
2. Before using the device, check the test leads for any
insulation damage. If the test leads have insulation damage
or cuts, do not use the device.
3. Do not input voltages higher than those in the specification.
4. During measurements do not change the position of the
rotary switch.
5. Take extra precaution while measuring voltages above 60
V DC and 30 V AC.
6. Before measurement position the rotary switch to correct
position and connect the test leads to the proper terminals.
7. Do not use the device in temperatures exceeding the range
in specification, in high humidity, and near explosives and
flammables.
8. During measurement, hold the test leads by the finger guards.
9. Before measuring resistance, continuity, diodes and hFE,
disconnect the measured circuit from power and discharge
all capacitors.
10. If the display shows low battery icon, change the batteries.
Otherwise the accuracy of measurements may be decreased.
11. Before opening the battery case disconnect the test leads
from measured circuit and from the device.
12. Spare parts (battery and fuse) must be replaced for a new
ones and with the same specification.
13. Do not tamper with devices internal circuits. This may lead
to accuracy decrease or damaging the device.
14. The device is intended for indoors use only.
15. Take out the batteries, if the device is not going to be used
for a long time.
EN
10