Maintenance And Storage - Wahoo KICKR BIKE Bedienungsanleitung

BEFORE EACH RIDE
• Check to ensure that stem bolts are tight and that handlebars cannot rotate.
• Confirm that your saddle is properly installed and all bolts are properly tightened.
• Ensure that both the levers for adjusting reach and setback are fully closed.
• Check that the seatpost and steer tube quick release clamps are tightened
and fully closed.
• Ensure that the standover height pin is properly seated and resting in the
corresponding height position hole and that the lever is fully closed.
• That your pedals are properly installed and adequately tightened.
• Refer to this manual for proper torque specs.
• Before each ride ensure that the area is clear and that the KICKR BIKE has full range
of tilt motion.
• Level the KICKR BIKE's feet and make sure the floor is clear of any debris.
• Check the power cord and brick for any damage before plugging it in.
• Ensure the KICKR BIKE is in locked mode before starting your ride.

MAINTENANCE AND STORAGE

It is important to follow the below maintenance tips to ensure optimal performance
of your KICKR BIKE:
After each training session:
• Use a soft cloth to wipe the KICKR BIKE dry or remove any sweat or water.
• Unplug the KICKR BIKE when stored or plug into surge protector.
• Routinely check for signs of rust, corrosion, or excessive wear.
• Inspect all bolts and screws for rust or damage.
To move and store your KICKR BIKE, use the casters to move the KICKR BIKE to a safe
place for storage:
• Grab the handlebars and lift, then grab the front foot. Hold the front foot to navigate
to place of storage.
3