Operation - Kress KUC10 Handbuch

Plan your work schedule to spread any high vibration
tool use across a number of days.
ACCESSORIES
2.0Ah lithium battery
pack(KPB1202)
1.5A charger (KCH1202)
Holster KA1601
We recommend that you purchase your accessories
listed in the above list from the same store that sold you
the tool. Refer to the accessory packaging for further
details. Store personnel can assist you and offer advice.
OPERATION GUIDELINES
NOTE: Please read the instructions carefully
before use.
Usage
This tool is used to screw or drill holes in wood, metal,
plastic and to drill holes in lightweight concrete or
brick walls.
Installation and operation
STEPS
BEFORE OPERATION
Disassemble battery pack
Battery pack charging
Installation of battery pack
INSTALLATION
CHUCK ADJUSTMENT
Warning: When replacing
accessories, make sure that
the power supply is cut off and the
switch is turned off (the reversing
lever is in the middle position). When
starting the tool, make sure that there
is no hidden danger to the drill bit.
Damage or loosening of the chuck
may cause personal injury.
Drill bit disassembly
Installation of drill bit

OPERATION

Forward and reverse switching
Warning: The direction
of rotation can not be
changed until the machine is
completely stationary.
SPEED SHIFT
KUC10 KUC10.2 KUC10.9
2 2 /
1 1 /
1 1 1
Pictures
See Figure A1
See Figure A2
See Figure A3
See Figure B1
See Figure B2
See Figure
C1,C2,C3
See Figure D
TORSION ADJUSTMENT
Torque selection
The tripping torsion corresponding
to position 1 is the smallest, and that
corresponding to position 20 is the
largest.
Mode switch
Drilling mode
Screw batch mode
Hammer drill mode (drilling on
lightweight concrete and brick walls)
Start/stop
Warning: Do not use
start-stop switch for long
time and low speed operation,
otherwise the machine may
overheat and cause tool
damage.
LED indication
The LED will be lit when the switch
is pressed. When the switch is
released, the LED will automatically
go out.
The tool and battery are equipped
with automatic power-off protection
system. The LED flickers for
3 seconds and then goes off,
indicating that the protection system
works. At this time, the system
automatically cuts off the power
supply to prolong the battery life.
The following situations may trigger
automatic power-off protection:
• Overload: Tools are
overloaded when they are
running, the current is too high.
In this case, release the switch,
stop the operation leading to tool
overload, and restart the switch.
• Overheat: In the case above, if
the tool is not started, the tool and
battery may be overheated. In this
case, cool the tool and battery pack
before starting the switch again.
• Low voltage: The tool does
not work when the remaining
capacity is too low. In this case,
dismantle and replace the battery
pack.
Warning: Make sure the
reversing lever is on the left or
right, press the switch and the LED
light comes on.
FAQS
1. WHY HAS THE SWITCH BEEN PRESSED AND
THE MACHINE DOES NOT WORK?
There is a reversing lever at the top of the switch. When
it is in the middle position, the machine will lock the
start-stop switch. Put it where it needs to be turned and
press the button, the machine will start to rotate.
See Figure E
See Figure F
See Figure G
9
EN
See Figure G