ESX SE7000D Benutzerhandbuch Seite 22

INTERCONNECTION EXAMPLE 1 Subwoofer with a Single-Voicecoil
MASTER
NOTE
In this configuration both "–"
speaker outputs of the Slave and
Master amp must be connected by
any means.
INTERCONNECTION EXAMPLE 1 Subwoofer with a Dual-Voicecoil
MASTER
INTERCONNECTION EXAMPLE 2 Subwoofers with Single-Voicecoils
MASTER
Subwoofer 1
1 – 8 Ohms
INTERCONNECTION SUBWOOFER
• Connect the Subwoofer terminals with the speaker outputs (SPEAKER OUTPUT + / -) of both amplifiers by using appropriate wires.
• Always ensure the correct polarity of the speakers. The interchange of plus and minus cause total loss of bass playback and could
damage the speakers.
• Ensure by any means, that the total impedance load of subwoofer is not lower than described above.
• Too low impedance cause high temperature and will shut down the amplifier operation.
SE7000D
MASTER/SLAVE Link
like described on page 21.
Subwoofer
2 – 8 Ohms
MASTER/SLAVE Link
like described on page 21.
Subwoofer Voice Coil 1
1 – 8 Ohms
MASTER/SLAVE Link
like described on page 21.
The Impedance may not
be lower than 2 ohms.
Subwoofer Voice Coil 2
1 – 8 Ohms
NOTE!
The subwoofer voice coil 2 on the SLAVE amp needs
to be connected with a converse polarity.
The subwoofer 2 on the SLAVE amp needs
to be connected with a converse polarity.
22
SLAVE
SLAVE
SLAVE
Subwoofer 2
1 – 8 Ohms
NOTE!