Interconnection Example Master/Slave-Mode - ESX SE7000D Benutzerhandbuch

INTERCONNECTION EXAMPLE Master/Slave Mode
Remote wire REM
1.
Remote wire REM
INTERCONNECTION MASTER
• Connect the RCA lineouts of the headunit with the RCA jacks LINE INPUT of the amplifier with appropriate high-value RCA cables.
If your headunit is equipped with a additional subwoofer lineout (SUB OUT), it is recommended to use this lineout.
• Connect the remote wire (REM) to the remote terminal (REM) of the MASTER amp.
• Connect the bass remote wire only on the REMOTE port of the MASTER amp.
INTERCONNECTION SLAVE
• Connect the RCA jacks SLAVE IN/OUT of the MASTER amp with the RCA jacks SLAVE IN/OUT of the SLAVE amp with appropriate
high-value RCA cables.
• Connect the remote wire (REM) of the remote terminal (REM) of the MASTER amp with the remote terminal (REM) of the SLAVE amp.
Use therefore cable with a minimum profile section of 0,5 mm
INTERCONNECTION SUBWOOFER
• Check page 22.
SETTINGS MASTER
• The MODE switch should be in MASTER position.
Check the information LOW PASS, SUB SONIC, PHASE, LEVEL, SUB BOOST, FREQ RANGE, Q-CONTROL and BASS REMOTE
on page 20.
SETTINGS SLAVE
• The MODE switch must be in SLAVE position.
In the SLAVE mode all controllers of the SLAVE amp are without function.
Only the already modified audiosignal of the MASTER amp will be amplified.
NOTE!
The Master/Slave-Mode is only possible with two identical SE7000D amplifiers.
SE7000D
Connect the bass remote
controller and the remote terminal
at the amplifier (MASTER)
with the enclosed cable.
MASTER
Switch setting = MASTER
1. Connect Stereo RCA output (L/R
or SUB OUT) of the headunit with the
LINE INPUT CH1/2 of the MASTER amp
2. Connect Stereo RCA output (SLAVE IN/OUT)
of the MASTER amp with the SLAVE IN/OUT
of the SLAVE amp
2.
Remote wire REM
.
2
21
SLAVE
Switch setting = SLAVE