Operation; Menu Structure - EuroLite AF-7 Bedienungsanleitung

Occupation of the XLR connection:
If you are using controllers with this occupation, you can connect the DMX output of the controller directly
with the DMX input of the first device in the DMX chain. If you wish to connect DMX controllers with other
XLR outputs, you need to use adapter cables.
Building a serial DMX chain:
Connect the DMX output of the first device in the DMX chain with the DMX input of the next device. Always
connect one output with the input of the next device until all devices are connected.
Caution: At the last fixture, the DMX cable has to be terminated. Plug the terminator with a 120
between Signal (–) and Signal (+) in the DMX output of the last fixture.

OPERATION

After you connected the device to the mains, the device starts running.
The LED display lights up and you can now choose the desired settings via the buttons MENU, UP, DOWN
and ENTER.
The device has two operating modes. The wind speed of the fan can be adjusted in stand-alone mode via
the rotary control or in DMX-controlled mode via any standard DMX controller.

Menu structure

The main menu is accessed by pressing Menu until the display is lit. Browse through the menu by pressing
Menu. Press Enter in order to select the desired menu. You can change the selection by pressing Up or
Down. Press Enter in order to confirm. You can leave every mode by pressing Menu. The functions provided
are described in the following sections.
Mode
Wind speed
DMX mode
Fan, hold
Display turn off
Software version
Display
SPed 000 - 099
Addr
d001-512
on
oFF
bLNd
hoLd
on
10oF
dISP
30oF
60oF
uer uxxx
17/20
Function
Wind output - from off (000) to
maximum (099)
DMX start address setting
Fan on
Fan off
Keeps the last DMX setting if there is
no longer data being received at the
DMX-input
Display turn off when the buttons are
inactive
on - Display always on.
xxoF - Shuts off the display after
about 10, 30 or 60 seconds
Software version
00113686.DOC, Version 1.0
Ω resistor