Denon Professional DN-500BD MKII Benutzerhandbuch Seite 14

Additional Functions
To select a Repeat mode, press Repeat on the remote control, or press Shift and Skip Back (
DN-500BD MKII. It will cycle through 3 modes:
•
Off: Normal operation.
•
Repeat Track: The current track will repeat continuously. In this Repeat mode, pressing
will Skip Back/Forward (
•
Repeat All: The current title will repeat continuously.
To select a playback mode, press Random on the remote control. It will cycle through 3 modes:
•
Shuffle: Tracks on the CD will play in a random order without repeating. When all tracks on the CD
have played, playback will stop (unless a Repeat mode is selected).
•
Random: Tracks on the CD will play in a random order. Playback will continue indefinitely. Also,
tracks will also be allowed to play more than once.
•
Off: Normal operation.
To loop a section of the track:
1. Set the desired starting point by pressing A-B on the remote control, or press Shift and Skip Forward
( ) on DN-500BD MKII. A- will appear on the screen.
2. Set the desired ending point by pressing A-B on the remote control again, or press Shift and Skip
Forward ( ) on DN-500BD MKII again. A-B will appear on the screen, and the loop will start and
repeat continuously.
3. To stop the loop, press A-B on the remote once more, or press Shift and Skip Forward (
500BD MKII once more. A-B will disappear from the screen, and playback will continue normally.
To jump to a specific track of the disc:
1. Use the number buttons (0–9) on the remote control to select the number of the desired track.
2. To confirm your choice, press OK or wait a few seconds. The desired track will start playing.
To cancel, press Clear.
To jump to a specific track or time of the disc:
1. Press GoTo on the remote control. The Information panel will appear at the top of the screen. (To
cancel the operation before selecting a track or time, press GoTo again or wait until the blue square
cursor in the Information panel disappears, and then press Info.)
2. Use the left/right cursor buttons () to select either of the available fields:
• Track: Press OK to "unlock" this field. Use the up/down cursor buttons () or number
buttons (0–9) to select the number of the desired track, and then press OK to jump to it.
• Time: Use the up/down cursor buttons () to select whether these 3 fields show the
elapsed time for the Track or Disc. After that, press OK to "unlock" these 3 fields. Use the
left/right cursor buttons () to select each field: hours, minutes, and seconds. Use the
up/down cursor buttons () or number buttons (0–9) to enter each as a 2-digit
number. Press OK to jump to that time in the track or disc.
3. To jump to another location, repeat Steps 1–2.
To close the Information panel, press Info.
14
/ ) will skip to the beginning of the current chapter only.
) on
All
) on DN-
TRACK TRACK
DISC DISC