Intended Use - Makita DTD154 Betriebsanleitung

ENGLISH (Original instructions)
SPECIFICATIONS
Model:
Fastening capacities
No load speed
Impacts per minute
Rated voltage
Overall length
Net weight
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi-
est combination, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge
Charger
• Some of the battery cartridges and chargers listed above may not be available depending on your region of
residence.
WARNING:
Only use the battery cartridges and chargers listed above. Use of any other battery cartridges
and chargers may cause injury and/or fire.

Intended use

The tool is intended for screw driving in wood, metal
and plastic.
Noise
The typical A-weighted noise level determined accord-
ing to EN62841:
Sound pressure level (L
Sound power level (L ) : 107 dB (A)
WA
Uncertainty (K) : 3 dB(A)
The noise level under working may exceed 80 dB (A).
WARNING:
Wear ear protection.
Machine screw
Standard bolt
High tensile bolt
Hard impact mode
Medium impact mode
Soft impact mode
T mode
Hard impact mode
Medium impact mode
Soft impact mode
T mode
) : 96 dB(A)
pA
BL1815N / BL1820 / BL1820B / BL1830 / BL1830B / BL1840 /
BL1840B / BL1850 / BL1850B / BL1860B
DC18RC / DC18RD / DC18RE / DC18SD / DC18SE / DC18SF
Vibration
The vibration total value (tri-axial vector sum) deter-
mined according to EN62841:
Work mode: impact tightening of fasteners of the maxi-
mum capacity of the tool
Vibration emission (a
Uncertainty (K) : 1.5 m/s
NOTE: The declared vibration emission value has
been measured in accordance with the standard test
method and may be used for comparing one tool with
another.
NOTE: The declared vibration emission value
may also be used in a preliminary assessment of
exposure.
4 ENGLISH
DTD154
4 mm - 8 mm
5 mm - 16 mm
5 mm - 14 mm
-1
0 - 3,600 min
-1
0 - 2,100 min
-1
0 - 1,100 min
-1
0 - 3,600 min
-1
0 - 3,800 min
-1
0 - 2,600 min
-1
0 - 1,100 min
-1
0 - 2,600 min
D.C. 18 V
117 mm
1.2 - 1.6 kg
2
) : 12.5 m/s
h
2