Nature7 BEAM 569610 Bersetzung Der Ursprünglichen Bedienungsanleitung Seite 17

Buttons (fig. 10):
MIS T BU T TON
(mist generation control)
First press: The „CONT." indicator is
lit and continuous mist generation is
activated.
Second press: The „10 SEC." indicator
is lit and intermittent mist generation is
activated.
Third press: Mist generation is turned off.
1× Continuous 2×
operation
CONT. 10SEC.
GB
32
LIG HT BU T TON
(Light control)
First press: Gradual turning on and off of
the light.
Second press: The light intensity is set at
the level of the light at the moment when
the button was pressed a second time.
Third press: The light is turned off.
Note:
The light and mist generation are
controlled independently of each other.
The light can be turned on even without
water in the water tank, whereas mist
generation cannot.
Intermittent 3×
Stop
operation
CONT. 10SEC. CONT. 10SEC.
IV. Maintenance
S TE P 1
Press the respective button to turn the
mist generation and/or light off (fig. 10).
S TE P 2
Disconnect the power adapter from the
power socket (fig. 11).
S TE P 3
Disconnect the power cord from the
power adapter (fig. 12).
S TE P 4
Remove the cover (fig. 13).
•
WARNING
Do not pour water out through the
vent (fig. 14).
Pour the water out of the water tank
via the pour out groove (see point 4 in
descriptive picture) (fig. 14).
After pouring out the water, wipe the
water tank of the aroma diffuser using
a personal hygiene product (fig. 15).
If there is limescale inside the water tank,
wipe it out thoroughly using a textile
soaked in limescale remover (e.g. solution
of food-grade citric acid). Cleaning agent
must not be poured into the water tank of
the aroma diffuser. Subsequently fill the
water tank several times with water and
wipe it dry.
GB
33