Installation; Electrical Connection - AIRFORCE F129 50 K3 Montage- Und Gebrauchsanweisung

GB INSTRUCTION ON MOUNTING AND USE
Check also the drawings on the initial pages with the alphabetical
and numerical references in the explanatory text.
Closely follow the instructions in this manual. We cannot
accept liability for any faults, detriment or fire damage to the
appliance due to non-compliance with the manual's
instructions. Installation and electrical connections must be
executed by a qualified technician. You should affix the hood
to a wall of sufficient weight-bearing capacity, so not to one
made of plasterboard. Do not install it inside a cupboard.

Installation

The cooker hood must be placed at a minimum distance of 60
cm from the cooking plane for electric cookers and 60cm for
gas or mixed cookers.
If the instructions for installation for the gas hob specify a greater
distance, this has to be taken into account.
Do not tile, grout or silicone this appliance to the wall. Surface
mounting only. Do not fix chimney flue to furniture or fly over
shelves unless the chimney flue can be easily removed, in
case maintenance is ever required.
Use
The cooker hood is provided with an upper air exit B for
discharging fumes externally for models including chimney
flue C ( Suction Version A- exhaust pipe not supplied).
If cooking fumes and vapours cannot be externally discharged,
the cooker hood can be used in the recirculating version
F: the installation of 1 active charcoal filter F allows the
recirculation of fumes and vapours through the upper grid G.

Electrical connection

Make sure that there is a power socket near the hood and
that the system has a 30 mA differential. The mains voltage
must be the same as that on the label inside the hood. The
hood has a 1250 mm power cable with or without plug: if it
does have a plug, connect the hood to an accessible
approved socket; or if it does not (connection direct to the
mains), fit an approved bipolar switch with a minimum
contact opening of no less than 3 mm (accessible). This
installation and electrical connection must be executed by a
qualified technician.
Operation
Light key: Lights ON/OFF
Key 1: activates the motor at level-one suction power;
press key 1 to turn it off.
Key 2: activates the motor at level-two suction power;
press key 2 to turn it off.
Key 3: activates the motor at level-three suction power;
press key 3 to turn it off.
To turn off the motor, the suction power keys must be in their
original position.
K3
1 2 3
Operation
1
Light key: Lights ON/OFF.
Key 1: activates the motor at level-one suction power;
press key 1 to turn it off.
Key 2: activates the motor at level-two suction power;
press key 2 to turn it off.
Key 3: activates the motor at level-three suction power;
press key 3 to turn it off.
Key 4: activates the motor at level-four suction power;
press key 4 to turn it off.
To turn off the motor, the suction power keys must be in their
original position.
S4
2 4
3