Solving Problems; Disposal Of Your Old Appliance; Technical Details - Montiss KFP5777M Gebrauchsanleitung

SOLVING PROBLEMS

Nr. Problem
The appliance does not go
1
on.
The appliance suddenly
2
stops running.

DISPOSAL OF YOUR OLD APPLIANCE

1. When this crossed-out wheeled bin symbol is attached to a product it means the product is
covered by the European Directive 2002/96/EC.
2. All electrical and electronic products should be disposed of separately from the municipal
waste stream via designated collection facilities appointed by the government or the local
authorities.
3. The correct disposal of your old appliance will help prevent potential negative consequences
for the environment and human health.
4. For more detailed information about disposal of your appliance, please contact your city
office, waste disposal service or the shop where you purchased the product.

TECHNICAL DETAILS

Model number
Power
Nominal voltage
Nominal frequency
Montiss is a registered brand name of:
Van den Berg Products BV
IJzerwerf 10-12
6641 TK Beuningen
The Netherlands
www.vdbergproducts.com
Possible solution
Make sure that all assembly indications (on the lid of
the bowl, on the bowl, on the blender jar and on the
motor unit) are aligned.
The lid of the bowl may have become undone during a
heavy processing job. Close the lid properly. The device
immediately starts working again.
The processing job is too heavy. Set the control knob to
'off' to switch off the device and remove the mains plug
from the wall socket. Then let the device cool down to
room temperature. Plug in the device and switch it on
again. Process smaller batches.
KFP5777M
max. 1000W
220-240V~
50Hz
25