Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
Installing the SIM NANO and microSD card
Before installing the cards, turn off the phone and
follow the graphic on page 3.
1. Use the clip from the package to open the phone
cover - use a hook located on the clip.
2. Then push the pin on the buckle into the hole
under the phone cover - this will cause the card
holder to eject. The holder is then completely
removed from the phone using the hook on the clip.
You can now insert cards: a) 2x NANO SIM or b) 1x
NANO SIM and 1x microSD card
3. Slide the entire bin with the cards back into the
phone, see. drawing on page 3. You can again use
the hook from the buckle to insert it. Close the
phone cover carefully again.
Charging the battery:
Before putting your phone into service you must
recharge its battery for 100%.
1. Connect the adapter to the charger
2. Connect the charger to the wall outlet.
3. If the battery is fully charged, disconnect the
phone from the charger.
Switching the phone on / off / sleep mode
Make sure that the phone has a SIM card and the
battery is fully charged.
Press the ON button to switch on the phone.
Switch off the phone by pressing ON and select
OFF. Confirm it by pressing OK.
33
Werbung
