Candy FF2-55 Bedienungsanleitung Seite 18

Problem Possible cause
Temperature is
set too cold or
the appliance
runs at SUPER
modes,
Temperature is
not properly
adjusted.
Door was open
for an extended
period.
The food is not
A large quantity
frozen enough.
of warm food was
placed in the
appliance within
the last 24 hours.
The appliance is
near a heat
source.
Door seal is not
air light.
Heavy build up of
frost on the door
seal.
Appliance is not
level.
The appliance is
touching the wall
or other objects.
A component,
Unusual noises
e.g. a pipe on the
rear of the
appliance is
touching another
part of the
appliance or the
wall.
It's normal. Heat
Side panels are
exchange is in the
hot
side panels.
If the malfunction shows again, contact the Service
Center.
These data are necessary to help you quickly and
correctly. Write the necessary data here, refer to the
rating plate.
18
Solution
Turn the
temperature
regulator to a
warmer setting
temporarily.
Please look in the
initial
Temperature
Setting section.
Open the door
only as long as
necessary.
Turn the
temperature
regulation to a
colder setting
temporarily.
Please look in the
installation
location section.
Carefully warm
the leaking
sections of the
door seal with a
hair dryer (on a
cool setting) At
the same time
shape the
warmed door seal
by hand such
that it sits
correctly.
Re-adjust the
feet.
Move the
appliance slightly.
If necessary,
carefully bend
the component
out of the way
Take gloves to
touch side panels
if need.