YATO YT-82834 Bedienungsanleitung Seite 13

PRODUCT CHARACTERISTICS
Hedge trimmer is designed for trimming and forming of bush crowns and trimming of thin branches. Adding the extension arm
made it possible to form the hedge of even signifi cant height. Due to electric drive of the trimmer, operation is much more noiseless
than in case of combustion engines, it is also possible close to buildings. Thanks to battery power operation, a trimmer make it
possible to work in places inaccessible for products powered from mains. Correct, reliable and safe operation of the tool depends
on proper operation, therefore:
Before starting the work with this tool, please read this manual and keep it properly.
The supplier does not assume any liability for any damages resulting from misuse of the tool, failure to follow safety regulations
and recommendations specifi ed in this manual. Misuse of the product will also result in loss of guarantee and warranty rights of
the user.
PRODUCT ACCESSORIES
The product is supplied as complete, however before fi rst use also assembly is required.
Supplied with the trimmer: blade cover, battery, docking station and carrying strap.
Note! Product of a catalogue number: YT-82835 has not been equipped with battery and docking station.
TECHNICAL DATA
Parameter
Catalogue number
Rated voltage
Cutting speed
Cutting length
Max. cutting diameter
Electrical protection class
Weight (without battery, guide rail and chain)
Noise level
- L (pressure)
pA
- L (power)
wA
Oscillations (rear handle / front handle)
Battery type
Battery capacity*
Battery energy*
Docking station*
Input voltage:
Mains frequency
Rated power
Output voltage:
Output current:
Charging time**
* only in models equipped with battery and charger
** specifi ed charge time refers only to battery of capacity mentioned in the table
GENERAL SAFETY CONDITIONS
NOTE! Get acquainted with all the instructions below. Failure to observe them may lead to an electric shock, fi re or injuries. The
notion of electric tool used in the instructions applies to all the tools which are powered with electric current, both wire tools and
wireless ones.
OBSERVE THE FOLLOWING INSTRUCTIONS
Place of work
The place of work must be properly illuminated and clean. Disorder and poor illumination may be a cause of accidents.
Do not work with electric tools in explosive environments, or those which contain infl ammable liquids, gases or vapours.
Electric tools generate sparks, which may cause a fi re in case of contact with infl ammable gases or vapours.
Do not allow children and outsiders to the place of work. A lack of concentration may result in a loss of control over the tool.
O R I G I N A L
GB
Measuring unit
[V]
[min -1 ]
[mm]
[mm]
[kg]
[dB] (A)
[dB] (A)
[m/s 2 ]
[Ah]
[Wh]
[V~]
[Hz]
[W]
[V]
[A]
[h]
I N S T R U C T I O N S
Value
YT-82834, YT-82835
18 DC
2100
420
12
III
4.1
77.3±3.0
88.1±3.0
1.5±1.5
Li-ION
2
36
220-240
50/60
60
21 DC
2.4
1
13