Manual Screen Adjustment - Sharp LL-T2015 Bedienungsanleitung

Adjusting the screen display

Manual screen adjustment

Adjustments can be made using OSD (On Screen
Display) Menu provided.
On Screen Display for adjustment
If you are using Windows, open the Adjustment
Pattern on the accompanying CD-ROM. (p.20)
If your system is not Windows, you can not use the
Adjustment Pattern. Therefore display an image
that makes the entire screen light and adjust it
through checking visually its actual tone.
This chapter provides the procedure how to adjust
the screen by using Adjustment Pattern (for
Windows).
How to adjust
1. Press the MENU button.
The ADJUSTMENT Menu will be displayed.
ADJUSTMENT
MANUAL AUTO
CLOCK 127
-
PHASE 0
-
H-POS 250
-
V-POS 48
-
INPUT-1 ANALOG
1600 x 1200 V:60Hz H:75.0kHz
At this point, relevant menu options can be
adjusted.
Each time the MENU button is pressed the next
menu is selected. (ADJUSTMENT
CONTROL COLOR CONTROL
SELECT-1 MODE SELECT-2
disappears)
Note:
- The OSD Menu automatically disappears
approximately 30 seconds after the last
command.
+
+
+
+
GAIN
MODE
OSD Menu
21
(With analog connection)
ADJUSTMENT Menu
ADJUSTMENT
MANUAL AUTO
CLOCK 127
-
PHASE 0
-
H-POS 250
-
V-POS 48
-
INPUT-1 ANALOG
1600 x 1200 V:60Hz H:75.0kHz
MANUAL: Individual menu options are manually
adjusted.
AUTO: Every menu option is automatically
adjusted.
Notes:
- Press the button to select [AUTO].
- To choose a menu option:
- To go to the next menu: MENU button
CLOCK
The figure below demonstrates how to adjust so that
vertical flicker noise is not emitted. (
Vertical flicker noise
PHASE
The figure below demonstrates how to adjust so that
horizontal flicker noise is not emitted. (
Note:
- Adjustments to [PHASE] should be made only
after [CLOCK] has been correctly set.
Horizontal flicker noise
H-POS (horizontal positioning) and V-POS
(vertical positioning)
To center the Adjustment Pattern within the
boundaries of the screen, adjust the left-right (H-
POS) values and the up-down (V-POS) values.
( buttons)
Screen frame
Adjustment
Pattern
+
+
+
+
/ MODE button
buttons)
buttons)