DENIOS. SpillGuard Kurzanleitung Seite 20

Press and hold the button until the beep
3.
is heard.
1 beep
LED flashes quickly
LED
4. The calibration process is complete after
approx. 30 seconds.
2 beeps
LED flashes once a minute
LED
SpillGuard® is ready for operation.
5.3 Alarm procedure
After detecting a leak the following alarms
are given:
5 beeps, 15 s pause
Fast flashing during the pause
LED
20/42
SpillGuard® Quick Guide | 271433 | Rev. 2
Press the button (>1s and <10s)
1.
1 beep
The alarm is turned off .
i
INFORMATION
When handling hazardous substances,
observe the safety instructions in the
safety data sheet for the leaked hazardous
substance.
Carry out measures to clean up the leak.
1.
CAUTION
• Hazard from direct contact with the
hazardous substance
• Injury possible to hands, eyes etc
• Wear personal protective equipment (PPE)
Remove liquids from the spill sump and
2.
clean.