Requirements For The Installation Location - DENIOS. SpillGuard Kurzanleitung

Opening of the SpillGuard® housing is not
W
permitted.
The battery must not be changed.
W
A list of substances which are not suitable
W
to be used with SpillGuard® can be found
here:
www.denios.com/spillguard
These substances are prohibited for use
without exception.
2.4. Limited duration of use
SpillGuard® cannot be used once it has
W
detected a leak and must be replaced.
Due to its construction SpillGuard®
W
must be replaced at the latest
after 5 years, to guarantee successful leak
detection.
i
INFORMATION
The SpillGuard® battery must not be replaced!
3. Requirements for the
installation location
SpillGuard® is is mainly to be used in the
bottom of a spill sump.
The following prerequisites must be met:
The base of the spill sump must be free of
W
any type of contamination.
SpillGuard must be aligned parallel to
W
the ground.
There must be suffi cient space available
W
for SpillGuard®.
The installation location should be at the
W
lowest point of the spill sump so that a
leak is detected as early as possible.
WARNING
• The product must not be exposed to
damage caused by containers being put
into or taken out of storage.
• There is a risk of explosion and this can
lead to serious injuries!
• Place and operate the equipment in such
a way that damage is excluded.
SpillGuard® Quick Guide | 271433 | Rev. 2
17/42