DeLOCK 90280 Bedienungsanleitung Seite 7

English
Beep indication
single long beep
single beep
single short beep
two beeps
two short beeps
three beeps
three short beeps
four beeps (Hi-Lo-Hi-Lo)
five beeps
several short beeps
LED indicator
off
flashing blue
one blue flash
flashing red
solid red
Establish a Bluetooth connection
For the wireless communication there are two different modes.
HID (standard):
Disconnect
.E031$
1. Press the trigger for 1 second to activate the scanner.
2.
Scan [DISCONNECT]
3. Scan [BT mode - HID]; the scanner will emit several short beeps.
4. Select "Wireless Scanner" from discovered device list.
5.
The wireless application may prompt you to scan a pin code (see Pin Code Setup), which has been generated
automatically.
6. The scanner will beep twice to verify the connection.
Scanner is activated
Barcode is read correctly
The scanner reads a Code39 of ASCII in configuration procedure.
Bluetooth connected
The scanner reads a configuration barcode successfully.
Bluetooth disconnected
1.
The scanner reads a barcodes while disconnected.
2. The scanner reads an unexpected barcode during configuration procedure.
(scan [ABORT] to abort and start over)
out of range / poor connection
low rechargeable battery condition
The scanner changes during configuration from one communication mode to
another.
standby or power off
ready to connect (pairing) / disconnected
Barcode is read correctly
low rechargeable battery condition
charging
-7-
BT mode - HID
.E043$