DeLOCK 90280 Bedienungsanleitung Seite 2

English
Precautions when reading
________________________________________________________________________________________________
CHECK VERSION
DEFAULT
RESET / ABORT
________________________________________________________________________________________________
Reading Mode Setting
LED is always on.
The trigger does not function in Continuous Mode.
The LED is on steady if a barcode is close to the scanner, but starts flashing if no barcode is
detected after 60 seconds.
The trigger does not function in Flash Mode.
The LED will light when the trigger is pressed.
The LED will go off when the trigger is released.
The LED is always on when the trigger is pressed.
The LED will go off if no barcode has been detected after 60 seconds.
This function works like Trigger Mode, but the scanner beeps to indicate a good read.
Factory Scanability Test
-2-