Operation - Laserworld Club Serie Bedienungsanleitung

8. Operation

1. Connect the power cable to the device and then to the mains
2. Insert key and turn it ‚ON'
3. Press „ON" to switch the device on
4. The Interlock adapter is already attached. There is no need to change
anything. The show laser doesn't work if the Interlock adapter isn't connec-
ted to the device.
5. Safety Presets
This device has an integrated Scan Fail Safety (SFS). Is the Scan Fail Safety
active (on), single beams are prevented. If the Scan Fail Safety is switched
off always ensure that maximum permissible exposure (MPE) is not
exceeded in areas accessible to the public or members of staff.
6. Modes:
Your device runs in auto mode (random playback of the preset patterns):
Your device runs in music mode (random playback of the preset patterns
according to music, sound or any other noises):
Control the music sensitivity by the trim pot at the rear side of the device.
The Microphone LED (at the front side of the device) is flashing when the
device is triggered.
Your device runs in DMX mode if '10' is switched off:
EN page 9 / 12
Manual: Club Series MKII