Cleaning, Maintenance And Storage; Protecting The Environment - Black & Decker VH 900 Handbuch

Warning! The hole in the inflator
adaptor acts as a relief valve to prevent
over-inflating. Do not permanently cover
the hole.
Resetting the motor thermal safeguard
The motor of the appliance is fitted with
a thermal safeguard. This device
automatically switches the appliance off
in case of overheating. If this occurs,
proceed as follows:
Switch the appliance off and remove
x
the plug from the wall socket.
Allow the unit to cool. When the unit
x
has cooled down, check and clean
the filters.
Re-insert the plug in the wall socket
x
and switch the appliance on.
Emptying the container (fig. I & J)
When the container is full it should be
emptied. Always empty the container
into a waste bin outdoors.
Slide the container release button (3)
x
towards the back of the appliance to
release the container door (2).
Open the container door.
x
Empty the container as necessary.
x
Close the container door. Make sure
x
the container door clicks into place.
Cleaning, maintenance and
storage
Warning! Before cleaning and
maintenance, switch the appliance off
and unplug it.
From time to time wipe the
x
appliance with a damp cloth. Do not
use any abrasive or solvent-based
cleaner. Do not immerse the
appliance in water.
Cleaning the motor filter (fig. K & L)
The filter is re-usable and should be
cleaned regularly.
Remove the lid (22).
x
Take the filter (23) out of the
x
appliance.
Shake off excess dust by tapping the
x
filter into a dustbin.
ENGLISH
Refit the filter (23) into the appliance.
x
Refit the lid (22). Make sure the lid
x
(22) clicks into place.
Cleaning the exhaust filter (fig. M)
The filter is re-usable and should be
cleaned regularly.
Open the cover (17).
x
Pull the filter (24) from the retaining
x
pin.
Wash the filter in warm, soapy water.
x
Make sure the filter is completely dry.
x
Refit the filter (24).
x
Close the cover.
x
Replacing the filters
The filters must be replaced when
showing signs of wear or damage.
Replacement filters are available from
your Black & Decker dealer.
Remove the old filters as described
x
above.
Fit the new filters as described
x
above.
Storing the appliance (fig. N)
Flip up the power cord retainer (4).
x
Wind the cord around the container
x
and the retainer as shown.

Protecting the environment

Separate collection.
This product must not be
disposed of with normal
household waste.
Should you find one day that your
Black & Decker product needs
replacement, or if it is of no further use
to you, do not dispose of it with
household waste. Make this product
available for separate collection.
Separate collection of used
products and packaging allows
materials to be recycled and
used again. Re-use of recycled
materials helps prevent
environmental pollution and
reduces the demand for raw
materials.
7