Panasonic Elite Panaboard UB-T780 Bedienungsanleitung Seite 47

3.
Hang the elite Panaboard on the stand with the
screw heads.
4.
Secure the elite Panaboard to the stand frame
using the two-wing bolts (M5 ´ 12 mm [
count]) included with the stand.
Note
•
After installation is complete, use the
included cable holder to manage the power
cord and USB cable.
•
When installing the elite Panaboard on the
stand, you can adjust its height to 4 different
levels.
When changing the height, remove the left
and right screws from the back of the elite
Panaboard, and securely insert them at the
desired height. Torque (greater than 98 N·m
[10 kgf·cm (9 lbf·in.)]).
elite Panaboard Height
-100 mm (-4 in.)
Standard
+100 mm (+4 in.)
+200 mm (+7
5.
Wipe the screen board surface.
Gently wipe the screen board surface with a soft,
moist cloth.
/ in.] [2
1
2
Notice
•
Do not use thinner, benzene, or abrasive
chemicals to clean.
(Doing so can result in discoloration.)
•
Do not wipe the screen board with a dry
cloth.
(Doing so can cause static electricity build-
up.)
6.
Confirm that the elite Panaboard can operate.
See "Confirming the elite Panaboard
Operation" (page 46).
Operating Instructions (For Basic Operations)
Installation Manual
Screw Position
Highest
2nd from top
2nd from bottom
/ in.) Lowest
7
8
1
45