Red Sea ReefLED 50 Handbuch Seite 17

Turn OFF / Turn ON
One or all ReefLEDs can temporarily be turned off/on without physically
unplugging the device.
For individual units:
Device manager > Device line menu > Turn OFF / ON
For all ReefLEDs:
Device manager > Group line menu > Turn OFF / ON
Firmware Updates
From time to time you may receive a notification that a new firmware
version is available for your ReefLED. It is important to keep your ReefLED
firmware updated to ensure compatibility with updates to the ReefBeat
app.
If your ReefLED is not permanently connected to the internet, you will need
to connect it temporarily in order to update the firmware.
To update all ReefLEDs simultaneously:
.
Firmware Update
Individual ReefLEDs can be updated:
.
Firmware Update
Do not unplug the ReefLED while it is downloading and installing the new
software.
Device Manager > Device Line menu > About
firmware version.
When the firmware update is complete, the "About" page will show the
new version as the current version together with the date and time that the
update was performed.
All of your previous settings will remain as before.
If the firmware update is not successful, the ReefLED will automatically
revert to the previous version. Repeat the process a few minutes later.
.
.
Device manager > Group line menu >
Device manager > Device line menu >
– will show the currently installed
If your ReefLED does not seem to be performing correctly after the update,
disconnect and reconnect the power by the DC jack and wait for the
ReefLED to restart.
Tilt switch – (Not available on ReefLED 50 & 90 models)
Enabling the Tilt switch will automatically switch off the light when the
unit is tilted from the horizontal position such as when raising a unit
attached to the standard mounting arm.
The ReefLED is supplied with the Tilt switch disabled. To enable the Tilt
switch:
Device manager > Device line menu > Tilt Enable
Removing a ReefLED - Temporary
When switching off or physically removing a ReefLED temporarily such as
when doing reef-scaping or other maintenance on the aquarium, set the
unit to "Out-of-service" through the Device Manager to prevent ReefBeat
from giving you notifications that communication with the unit has been
lost. When returning the unit and/or switching it back on, remember to
return its status to "In-service". To change the status:
Device Line menu > In-service / Out-of-service.
Removing a ReefLED - Permanent
When permanently removing a ReefLED from an aquarium or before
resetting the unit's memory, delete the unit from the ReefBeat app:
Device Manager > Device Line menu > Delete.
Deleting before it is switched off will prevent unnecessary notifications
that communication with the unit has been lost.
Red Sea ReefLED
™
ENG
.
Device Manager >
17