Werbung
Verfügbare Sprachen
Verfügbare Sprachen
INSTRUCTION
1. UNFOLDING
Release transport safeguard. Tip forward to open until both catches can be seen and heard to engage.
2. REAR WHEEL ASSEMBLY
2a. Push the wheel onto axle until you hear a CLICK sound when the metal clamp catches groove
on the axle.
2b. To remove the rear wheel, push the plastic lever up and pull the wheel off.
3. FRONT WHEEL ASSEMBLY
To assembly the wheel, align the securing plate until the lugs on the plate engaged in the hole above
the axle. Tighten the screws and then lock the quick release lever. To remove the wheel, please
reverse the process.
4. INSTALL THE FRONTBAR
Install the front bar below the locking latches by pushing both locks until they lock onto the stroller
frame. You will hear a click sound when they secure onto the frame.
5. ADJUST THE BACKREST
To put the seat in the recline position, push up the plastic adjustor on both side at the same time
and adjustto the desired position. To set the seat in sitting position, push the back upwards.
6. BRAKE
To apply the brake, press the brake lever down with your foot. To unlock, lift up with toe. ALWAYS
USE FOOT-BRAKE WHEN THE STROLLER IS STOPPED.
Hand Brake : Squeeze the hand-brake lever to slow down the stroller.
7. FOLDING AWAY
Pull both latches upwards and tip the stroller backward to collapse. Secure with the transport
safeguard.
8. APPLYING FRONT BRAKE
The front brake is intended for slowing down the stroller. The front brake should only be used as
an additional means of securing the stroller when you park it. Always apply the parking brake when
parking the sports stroller.
9. CHECKING TYRE PRESSURE
You can pump up the pneumatic tyres with a normal tyre pump. The tyre pressure must not exceed
2.0 bar.
4
Werbung
