Pattfield Ergo Tools PE-ARM 36 Li Originalbetriebsanleitung Seite 291

switched off and the blade is not rotating. Lift the ejector fl ap (Fig. 13 /
Item A) with one hand. With the other hand, hold the grass basket by
the handle and hook it in from above (Fig. 13).
Filling level indicator of the grass collector
The grass collector is equipped with a fi lling level indicator (Fig. 2/
Item 24) which is opened by the air current that the lawn mower ge-
nerates during operation. If the fl ap closes during mowing, the grass
collecting device is full and must be emptied. To ensure the proper
functioning of the fi lling level indicator, the holes under the fl ap must
be kept clean and open.
Adjusting the cutting height
Warning!
Adjust the cutting height only when the engine is switched off and the
power cable has been disconnected.
Before you begin to mow, check to ensure that the blade is not blunt
and that none of the fasteners are damaged. To prevent any imba-
lance, replace blunt and/or damaged blades. To carry out this check,
fi rst switch off the motor and pull out the power plug.
The cutting height is adjusted as follows (see Fig. 14):
1. Push the lever (A) outwards.
2. Set the lever (B) to the desired cutting height.
3. Release the lever (A) and check that it is securely seated in the
lock.
Reading off the cutting height
The cutting height can be set between 25-75 mm in 6 intervals, and
can be read off on the scale (Fig. 14/C).
Anl_PE_ARM_36_Li_SPK7.indb 291 Anl_PE_ARM_36_Li_SPK7.indb 291
- 291 -
GB
07.12.15 13:37 07.12.15 13:37