Pattfield Ergo Tools PE-ARM 36 Li Originalbetriebsanleitung Seite 282

inside the battery may have suff ered serious damage. In this res-
pect, please also read the waste disposal information.
10. If the battery pack suff ers overloading and overheating, the inte-
grated protective cut-off will switch off the equipment for safety
reasons. Important. Do not press the ON/OFF switch any more if
the protective cut-off has actuated. This may damage the battery
pack.
11. Use only original battery packs. The use of other batteries may re-
sult in injuries, explosion and a fi re risk.
Information on chargers and the charging process
1. Please check the data marked on the rating plate of the battery
charger. Be sure to connect the battery charger to a power supply
with the voltage marked on the rating plate. Never connect it to a
diff erent mains voltage.
2. Protect the battery charger and its cable from damage and sharp
edges. Have damaged cables repaired without delay by a quali-
fi ed electrician.
3. Keep the battery charger, batteries and the cordless tool out of
children's reach.
GB
4. Do not use damaged battery chargers.
5. Do not use the supplied battery charger to charge other cordless
tools.
6. In heavy use the battery pack will become warm. Allow the battery
pack to cool to room temperature before commencing with the
charging.
7. Do not over-charge batteries. Do not exceed the maximum
charging times. These charging times only apply to discharged
batteries. Frequent insertion of a charged or partly charged batte-
ry pack will result in over-charging and cell damage. Do not leave
batteries in the charger for days on end.
8. Never use or charge batteries if you suspect that the last
time they were charged was more than 12 months previous-
ly. There is a high probability that the battery pack has already
Anl_PE_ARM_36_Li_SPK7.indb 282 Anl_PE_ARM_36_Li_SPK7.indb 282
- 282 -
07.12.15 13:37 07.12.15 13:37