Fitting the wheels (Figures 3a, b and 4)
Take the rear wheels (Figure 2/Item11) and mount them on the axle
as shown in Figure 3a. Then slide the washer (Figure 2/Item 23) onto
the axle and fasten all parts with the supplied split pin (Figure 2/Item
22) as shown in Figure 3b. Finally, press the wheel caps (Figure 2/
Item 10) onto the wheels (Figure 4).
Mounting the push bar (Fig. 5 to 10)
First take the spring (Figure 2/Item 16) and the handlebar mount (Fi-
gure 2/Item 12) and mount them on the relevant axle (Figure 5). Now
insert the push bar holder (Figure 2/Item 3) into the handlebar mount
(Figure 2/Item 12) and secure with the quick clamping function (Figu-
re 2/Item 17) (Figure 6).
The top push bar (Figure 1/Item 2) must be pushed onto the push
bar holders (Figure 2/Item 3) and secured as shown above in Figure
9. Then attach the power cable to the push bar (Fig. 10/Item A) using
the cable clips (Fig. 2/Item 18). Now you can select the push bar
height in three steps from 93.5 to 115.5 cm (Figure 7/Item A).
Notice!
GB
The handle height may only be adjusted within the marked range.
•
Press in the long handle and secure in the desired position using
the quick clamping function (Figure 7/Item B)
Warning!
Always set the identical handle height on both sides.
•
Use the cable clips to align the cable in accordance with the long
handle (Figure 10/Item A)
Mounting the grass basket (see Figs. 11 to 13)
First, plug the left (Fig. 2/Item 21) and right (Fig. 2/Item 20) part of
the housing together as shown in Figure 11. Then plug the top part of
the housing (Fig. 2/Item 19) onto the already mounted parts (Figure
12). Before you fi t the grass basket you must ensure that the motor is
Anl_PE_ARM_36_Li_SPK7.indb 290
Anl_PE_ARM_36_Li_SPK7.indb 290
- 290 -
07.12.15 13:37
07.12.15 13:37