Venga VG CMM 1 Handbuch Seite 11

Fax +32 2 359 95 50
USING THE STICK MIXER (motor unit and metal leg)
• Ensure that the unit is unplugged.
• Attach the shaft to the motor housing in such a way that the release buttons of the motor
housing are aligned with the notches of the shaft and apply gentle pressure until it clicks
into place. Then use gentle hand pressure only to ensure that the shaft is fully tightened
onto the motor unit.
• Put the ingredients into the bowl or a suitable container (such as a mixing bowl or pan).
Do not overfill to prevent splashing.
• Plug the unit into a suitable mains socket.
• Hold the unit securely and press the on/off button. We recommend that the motor unit is
operated in short on/off pulses.
• When mixing liquids ensure the blade is fully immersed before switching on the appliance
to prevent splashing.
• Never remove the unit from the liquid until the blade has totally stopped spinning.
USING THE CHOPPER (motor unit, chopper and bowl)
• Ensure that the unit is unplugged.
• First place the blade in the bowl.
• Add ingredients to the bowl. Some hard foodstuffs (e.g. carrots, cheese and meat) will
need to be chopped before being put into the bowl. DO NOT OVERFILL THE BOWL.
• Attach the opening of the lid to the motor housing in such a way that the release buttons
of the motor housing are aligned with the notches of the lid and apply gentle pressure
until it clicks into place. Then pull lightly on the lid to ensure that it is fully tightened onto the
motor unit.
• Place the lid on the container respecting the positioning of its openings-out. If necessary,
turn the lid until it is correctly placed on the container, then make it turn very lightly. Check
the locking of the lid by pulling on it lightly.
• Plug the unit into a suitable mains socket.
• Hold the bowl securely with one hand, and the motor unit with your other hand.
• Press the on/off button.
• NEVER remove the motor unit and lid of the chopper from the bowl until the blade has
stopped spinning.
• Only use the lid of the chopper, blade and axle unit in the bowl provided.
USING THE WHISK (motor unit, whisk body and removable stainless steel whisk)
• Attach the whisk body to the motor housing in such a way that the release buttons of the
motor housing are aligned with the notches of the whisk body and apply gentle pressure
until it clicks into place. Then use gentle hand pressure only to ensure that the whisk body is
fully tightened onto the motor unit.
• Insert the whisk into the whisk body, making sure that it is tight.
• Press the on/off button.
• Do not touch the whisk while it is moving.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
11
Assembly page 11/52
VG CMM 1 - 101216