Venga VG CMM 1 Handbuch Seite 10

Fax +32 2 359 95 50
The appliance is designed for the preparation of small quantities of food that have to be
consumed rather quickly. It is not designed for the preparation of large quantities at once.
Never touch the blade when the appliance is in use. Furthermore, never try to stop the
movement of the blade in any way whatsoever.
We recommend that when using your product you operate the motor unit in short on/off
pulses. This will give better chopping, mixing, etc. It will also ensure a long-lasting
performance of your motor. Please refer to the information at the end of this instruction
booklet for recipe information and operating guidelines.
The chopper is designed to be used exclusively in its delivery state (bowl, lid and blades in
good state) because it gives all the needed securities. Do not try to substitute one of those
pieces by another one and if you have to replace one, contact your after sales service.
Competent qualified electrician: after-sales department of the producer or importer or any
(*)
person who is qualified, approved and competent to perform this kind of repairs in order to
avoid all danger. In case of need you should return the appliance to this electrician.
IMPORTANT INFORMATION
This appliance is not intended for long-lasting use. You should never exceed the maximum
operating time indicated in the table below (see page 12). Failure to follow this instruction
carefully may result in damage to the motor. Please make some operation breaks regularly.
The breaks should last at least 10 minutes.
BEFORE THE FIRST USE
• Remove all packaging, and check that no parts are damaged or missing.
• Read these instructions carefully!
• Wash the bowl, lid, chopper blade and axle unit in warm soapy water and dry thoroughly.
• Wipe the motor unit and lid of the chopper with a damp cloth.
• Rinse the detachable metal leg under warm running water, wipe the blade with a damp
cloth and dry thoroughly.
• Remove the stainless steel whisk from the whisk body and wash in warm soapy water, wipe
the whisk body with a damp cloth and dry thoroughly.
WALL-MOUNTING BRACKET
To make the storage easier, your appliance is delivered with a wall-mounting bracket that you
can fix directly onto the wall thanks to the screws and raw plugs provided. Therefore measure
the space between the two notches on the backside of the mount and then make a hole in
the wall at the desired height and slide the raw plugs. Place the mount facing the holes, the
screws in the raw plugs and screw until there is the least possible play between the screw
heads and the mount.
SPEED SETTINGS
Depending on the accessory you are using, we recommend you to use the following speed
setting.
STICK ATTACHMENT:
WHISK:
CHOPPER:
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
speed I or II
speed I
speed I or II
10
Assembly page 10/52
VG CMM 1 - 101216