Establish The Bluetooth Connection To The Helmet; Adjusting The Microphone Sensitivity - AKE BT-HC2 Handbuch

AKE Bluetooth Helmet Connector into pairing mode by turning it off and
on with the Bluetooth control button. Hold down the button when switching
on until the pairing mode is signaled by alternate blinking of the LEDs. Now
shortly press the control button twice. A short interrupting of the LEDs
indicate that all pairings are deleted. Then switch the Bluetooth Helmet
Connector off and on again. Now the device will again automatically go
into pairing mode.

Establish the Bluetooth connection to the helmet

If your Bluetooth helmet allows this, the devices connect automatically
after switching on the power supply.
LED-indication plug-in version:
synchron. red and blue blinking: Partner not available
1 x short blue
2 x short blue
3 x short red and blue blinking:
LED-indication build-in version (build in button with integrated display):
red
1 x short
green
1 x short
green
2 x short
red
3 x short
Control tone for Duplex communication
It is always possible to switch between duplex and stereo transmission by
shortly pressing the multifunction button (5). Please note, it's necessary to
switch to Duplex transmission, if the intercom is requested. The setting will be
stored.

Adjusting the microphone sensitivity

For this, the motorbike intercom should already be set correctly. For more
details, please see the operating instructions of the respective motorcycle
intercom.
Depending on the system, the trasmission quality and the speed limit for a
voice connection via bluetooth is always lower than the cable connection.
In addition the microphone signal may be louder or softer depending on
the built-in helmet bluetooth component.
For voice-operated systems (VOX) you can adjust the microphone sensitivi-
ty additional at the Bluetooth Helmet Connector. Trimmer (4) for maximum
sensivity turn completely to the right, for lowest noise completely turn
completely to the left.
blinking: Duplex connection enabled
blinking: Stereo connection enabled
Partner out of range.
blinking: Partner not available
blinking: Duplex connection enabled
blinking: Stereo connection enabled
blinking: Partner out of range.
on
: low high
off
, : high low
13