Scope Of Delivery; Attaching The Base Back Part - Thomashilfen Octopus Montage- Und Gebrauchsanleitung

Scope of delivery

The Octopus positioning harness is delivered pre-assembled. The scope of delivery
of the harness includes the base back, a 7-point seat vest with lockable belt buckles,
the corresponding key in multiple versions, two shoulder belts, four lap belts and a
crotch belt. In addition, the product comes with an instruction manual and a rescue
hammer with integrated belt cutter.
The Octopus positioning harness (9800006900003) consists of the following
parts:
Item No.
9700693580000
9700693570000
9800956020000
Assembly of Octopus

Attaching the base back part

Place the base back part, with the Thomashilfen logo readable, on the backrest of the
car seat. Put the headrest of the car seat in a high position for easier installation of the
harness. Then thread the two buckles with the inscription "Press" through the bars of
the headrest. Then adjust the headrest again.
Next, the lower metal buckles and the crotch belt are threaded between the back
and seat of the car seat. If necessary, folding the backrest down will make assembly
easier.
Finally, the metal buckles on the back are clicked in. Then the base back part is
secured by tightening the strap underneath the buckles. The crotch strap is threaded
through the hinged buckle.
CAUTION: If your car seat does not have a gap between the backrest and the seat
area, you will need the "691" belt extension accessory to use the product safely.
Fig. 1: Threading the head section
Fig. 2: Threading the foot section
Fig. 3: Clicking in metal buckles
Fig. 4: Tightening the metal buckles
Assembly and instructions for use – Octopus
Designation
Cushion for positioning harness (Octopus)
Safety hammer (Octopus)
Instruction manual (Octopus)
15