Technical Data; Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL LE-WS 115 Bedienungsanleitung

Anleitung LE-WS 115_SPK7
It is prohibited to use the machine on asbestos
materials!
Never use a cutting wheel for rough grinding.

TECHNICAL DATA

Nominal voltage: 230 V ~ 50 Hz
Power consumption:
Idle speed:
Max. wheel diameter:
Drive spindle thread:
Sound pressure level LPA:
Sound power level LWA:
–
Vibration
a
w
Weight
Totally insulated
Cleaning, maintenance and ordering
of spare parts
Always pull out the mains power plug before starting
any cleaning work.
Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts of
the equipment. Ensure that no water can seep
into the device.
Carbon brushes
In case of excessive sparking, have the carbon
brushes checked only by a qualified electrician.
Important! The carbon brushes should not be rep
laced by anyone but a qualified electrician.
Maintenance
There are no parts inside the equipment which
require additional maintenance.
29.05.2006 15:18 Uhr
Ordering replacement parts
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
500 W
11.000 rpm
115 mm
M 14
83,9 dB(A)
96,9 dB(A)
2,8 m/s 2
2.1 kg
II /
Seite 11
GB
11