Before The First Use; Using The Coffee Maker - Westinghouse WKCM325 Bedienungsanweisungen

BEFORE THE FIRST USE

1. Carefully take the device and its accessories out of the packaging. Retain
the packaging in case you would like to store the device away or transport it
at a later date. If you choose to dispose of the packaging, then please do so
according to the applicable legal regulations.
2. Check the packaging contents for completeness and damages. Should the
contents in the packaging not be complete or be damaged, do not use the
device. Return it to your retail outlet immediately.
3. Clean the device and all accessories before the first use. Refer to the chapter
CARE AND MAINTENANCE.
4. For a perfect taste, carry out 2 or 3 boil-processes with fresh water (without
coffee). Once all the water has passed through, switch off the coffee maker and
let it cool down during 5 minutes. Then repeat the process with fresh water.

USING THE COFFEE MAKER

Preparation
When brewing coffee, always make sure that the coffee pot is clean. Residue in the
coffee pot may have a negative effect on the coffee's flavor.
1. Open the water tank cover and fill the water tank with water up to marking for
the desired number of cups. The level of water or number of cups can be read
using the level indicator of the water tank. Never fill the water tank above the
MAX marking. The MAX marking indicates the maximum number of cups per
brewing.
2. Swing the filter holder outwards.
3. Place a paper coffee filter or the supplied permanent filter into the filter holder.
4. Fill the desired amount of coffee grounds into the coffee filter.
5. Swing the filter holder back in until it clicks into place.
NOTE: Only place the coffee pot on the hot plate after the filter holder has been
swung back into place.
Starting the brewing process
DANGER OF BURNS! Do not lean over the steam escape opening as hot steam
escapes.
1. Slide the coffee pot with lid onto the hot plate. Make sure that the anti-drip
valve is pushed upwards during this step.
2. Unwind the power cord completely and connect the power plug to a suitable
power outlet.
3. Press the power switch to switch on the coffee maker. The power indicator light
goes on and the brewing process begins.
4. Once the all the water has run through the machine, press the power switch to
switch off the coffee maker. The power indicator light goes out and the machine
switches itself off.
5. Pull the power plug out of the power outlet after each brewing process.
6. Wait about 1 minute and remove the coffee pot from the coffee maker to pour
the coffee. Only touch the coffee pot by the coffee pot handle.
WKCM325_Coffee Makerr_5L_IB.indd 5
EN
5
11/11/2019 14:07:30