Werbung
Verfügbare Sprachen
Verfügbare Sprachen
GB
INSTRUCTION ON MOUNTING AND USE
Consult the designs in the front pages referenced in the text
by alphabet letters. Closely follow the instructions set out
in this manual. All responsibility,for any eventual
inconveniences, damages or fires caused by not complying
with the instructions in this manual, is declined.
Installation
The cooker hood must be placed at a minimum distance of 65
cm from the cooking plane for electric cookers and 75cm for
gas or mixed cookers.
If the instructions for installation for the gas hob specify a greater
distance, this has to be taken into account.
Do not tile, grout or silicone this appliance to the wall. Surface
mounting only. Do not fix chimney flue to furniture or fly over
shelves unless the chimney flue can be easily removed, in
case maintenance is ever required.
Use
The cooker hood is provided with an upper air exit B for
discharging fumes externally for models including chimney
flue C ( Suction Version A- exhaust pipe not supplied).
If cooking fumes and vapours cannot be externally discharged,
the cooker hood can be used in the recirculating version
F: the installation of 1 active charcoal filter F allows the
recirculation of fumes and vapours through the upper grid G.
Electrical connection
The electrical tension must correspond to the tension noted on
the label placed inside the cooker hood. Connect the electrical
plug, where provided, to the an easily accessible outlet in
conformity with local standards in force.
Where an electrical plug is not provided (for direct connection
to electrical network) place a standards approved bipolar
switch with an aperture distance of not less than 3mm
(accessible) from he contacts.
Operation
A
B
C
General notes: Any function can be activated by
pressing softly the button under the symbol.
A. ON/OFF light button: By essing this button the
hood's lights switch on.
B. ON/OFF motor button: By pressing this button the
extracting motor can be activated/stopped.
C.D.E.F. Speed regulator button: By progressing this
button the hood activates the selected extracting speed.
Funzione Timer: By pressing once again the Selectedspeed
button,the timer will last for 5 minutes. This function can be
applied to all 4 available speeds.
Grease filter saturation: After every 40 hours of use of the
hood, the button B indicator shows byflashing slowly that
the grease filters need to be washed.
Charcoal filter saturation: After every 120 hours of use of
the hood, the button B indicator by flasihing fast shows that
the charcoal filters need to be replaced.
D
E
F
Note: By pressing for at least 5 minutes the button E+F will
reset the filters saturation indicator.
Attention! This function should only be used after
performing the maintenance of the filters.
Automatic functioning through the heath sensor:
By pressing the button C D at the same time, the hood
starts the automatic functioning. The indicators of the 4 speeds
will flash in sequence . After more or less 30 seconds the
temperature sensor will start the motor choosing the right
extracting speed.The speed will change according to the heath
coming from the hob.
By pressing B the manual functioning can be restored.
Always clean the glass of the control for a correct
functioning.
A
B
Manual mode
The cooker hood is provided with 5 keys.
A: On / OFF lights
C: Speed reduction key. When the LED flashes the hood is
working on the minimum speed.
B: On/ Off key – The hood stars working at the same speed
used before switching it off the last time. To reset keep the C
key pressed for
D: Speed increase key. When the LED flashes the hood is
working at the maximum speed.
E: Timer. Pressing the E key the hood keeps on
functioning for some minutes and then stops automatically.
Lights ON/OFF
Motor speed ON/OFF
Reset filters
speed reduction switch
speed increase switch
Timer
Lights ON/OFF
Motor ON/OFF: at switch-on the hood starts at the
level at which it was switched off the last time.
5
C
D
E
Werbung
