Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Series 881
Installation and operation
"T SLOT"MAGNETIC POSITION DETECTOR
GB
REED SWITCH TYPE
for cylinders with "T" slot or dovetail grooves
DETECTOR CHARACTERISTICS
MAX. SWITCHING POWER
SWITCHING VOLTAGE
MAX. SWITCHING CURRENT
VOLTAGE DROP
(EN 60.947-5-2)
CONTACT RESISTANCE
INSULATION RESISTANCE
WITHSTAND VOLTAGE
SENSITIVITY
RESPONSE TIME opening
closing
REPEATABILITY
LIFE
WORKING TEMPERATURE
HOUSING
Thermoplastic housing (PA) with epoxy resin encapsulated printed circuit
DEGREE OF PROTECTION (CE I 529)
SIGNAL INDICATION
orange diode (LED) which lights up when the contact is established
PVC lead, 2 m long,
2 wires 0.14 mm
stripped and tinned
ends
CONNECTION
(3 possibilities / 4 types at choice)
2 metres
Weight (g)
21
Compatible
Description
cylinders
PES series 453
Reed switch type "T"
detector
+ mounting kit (1)
K
KN
881 00 733
(for direct mounting on
PEC
cylinders with "T" slot or
P2B - P2L
dovetail groove) (2)
(1) Detector supplied with mounting kit (integrated) for direct fitting to cylinder grooves
(2) Mounting of a T-slot detector in the dovetail groove requires an adapter (see accessories)
ACCESSORIES AND OTHER ELECTRICAL CHARACTERISTICS:
A separate Declaration of Incorporation relating to Council Directive 98/37/EC Annex II B is available on request.
Please provide acknowledgement number and serial numbers of products concerned.
This product complies with the essential requirements of the EMC-Directive 89/336/EEC and amendments. A
separate Declaration of Conformity is available on request.
6 W
10 to 30 VDC and AC
200 mA
< 3 volt (I = 200mA)
max. 0,15 Ω
> 100 MΩ
200 V DC
min. 2,5 mTesla (25 Gauss)
0,3 ms
0,1 ms
± 0,5 mm
10
7
operations (resistive load)
- 15°C , + 70°C
IP67
PVC lead, 5 m long,
0,15 m PVC lead + 3-pin
0.15 m PVC lead + 3-pin
2
,
2 wires 0.14 mm
2
,
plug-in male
screw-type male
stripped and tinned
connector and Ø M8
connector, Ø M12
ends
5 metres
51
7
CODES
881 00 734
881 00 735
881 00 736
see following page
1
MAXIMUM ELECTRICAL CHARACTERISTICS AND PROTECTION OF MAGNETIC DETECTOR (REED SWITCH)
Note: The switching point
must remain within the limits
of the shaded area. Any
excess voltage or power
may damage the detector.
INDUCTIVE
LOAD
RESISTIVE
LOAD
REED SWITCH CONNECTION :
0,15 m
0,15 m
14
ACCESSORIES
Extension cord made of PVC, length 5 m, 3 wires 0.25 mm 2
with 1 screw-type female M8 connector (other end stripped) (1) (2)
Extension cord made of PVC, length 5 m, 3 wires 0.25 mm 2
with 1 screw-type female M12 connector (other end stripped) (2)
Straight 3-pin female connector Ø M8, IP67
Right angle 3-pin female connector Ø M8, orientable by 90°, IP67
Cable cover and holder
(sold by the metre - minimum length = 1 m)
Set of 10 T-slot adapters for assembly to cylinders with dovetail grooves
(1) Extension cord for detectors with M8 connector.
(2) Detector connection: brown and black wires (non-polarised detector), blue wire not used.
(3) For your order please add the requested length (in metres) to the order code 881 00 746. Example:
l (mA)
DC
AC
200
150
PARTICULAR APPLICATIONS (valid for all models)
•
Detectors used for direct control of incandescent lamps:
100
The capacity specified on the lamp is based on its
resistance when hot. When switched on, the resistance
50
of the cold lamp is very low. Therefore, the current rises
V
V
quickly and may exceed the reed switch rating.
40
30
10
0 10 20 30 40
Allowance should therefore be made for the real power
20
of the cold lamp.
Load
With leads longer than 10 m, a 1000 Ω resistor must be
•
100 Ω
100 Ω
4 W
4 W
fitted in series with the detector to reduce the capacitive
R
effect caused by the wiring.
0,1 µF
0,1 µF
C
250 V
250 V
Load
R = 4 W resistor. Standard CCTU resistors code RP 59,
Protection
C = paper, polycarbonate or metallized mylar capacitor.
not necessary
The user is responsible for supplying and assembling of
components.
3 possibilities
View from male contact
side of connector
2 / 5 m
PVC lead outlet Ø 3 mm with stripped ends,
2 wires 0.14 mm
2
PVC lead outlet Ø 3 mm with 3-pin plug-in male
3
1
connector + screw Ø M8 (2 pins connected)
4
1
PVC lead outlet Ø 3 mm with 3-pin screw-type male connector,
3
4
Ø M12 (2 pins connected)
Description
2
The detectors reed switch
are not polarized
(Diode polarized)
brown +
blue -
CODE
5 m
br = 1
blu= 3 1
3
881 00 239
blk= 4
PVC
4
5 m
br = 1
1
2
881 00 238
blu= 3
blk= 4
4
3
PVC
3
1
881 00 202
CM5
4
1
3
4
881 00 203
CM5
(3)
881 00 746
881 00 745
2 m = 881 00 746 2
2,5 m = 881 00 746 3
Werbung
