OSRAM OPTOTRONIC Intelligent OTi DALI 75/220-240/1A4 NFC TW L Bedienungsanleitung

OPTOTRONIC
1)
OTi DALI 35/220-240/700 NFC TW L
OTi DALI 75/220-240/1A4 NFC TW L
A
7)
Input
6)
PE
DA
DA

Installing and operating information (SELV driver): Connect only
LED load type. LED module will be switched off when output voltage
drops below 15V or rises above 54V. Wiring information (see fig. A):
The light fixture maker is the final responsible for the proper PE
connection. Do not connect channel 1 and channel 2 of the output,
otherwise the LED driver or LED module can be damaged. No
galvanic separation between CH1 and CH2. Output current adjust-
ment = via software programming using the DALI Interface or via
Near Field Communication (NFC). Connect the unit to a DALI pro-
grammer (i.e. DALI magic) and run at a PC the software Tuner4TRONIC
– then follow the instructions. www. osram. com /dali. For Near Field
Communication please refer to Tuner4TRONIC, then follow the
instructions. www. osram. com /dali. Setting of DALI DT8 or DALI DT6
(2-channel mode) by Tuner4TRONIC software. Unit is permanently
damaged if mains is applied to the terminals 21-24. Lines 21/24
(21/22–23/24) max. 2 m whole length excl. modules. Emergency
lighting: This LED power supply complies with EN 61347-2-13
LED Power Supply
®
8)
Output
3)
picture only for reference, valid print on product 5)
picture only for reference, valid print on product 5)
9)
10)
Annex J and is suitable for emergency lighting fixtures according
to EN 60598-2-22. Hereby, OSRAM GmbH declares that the
radio equipment types OTi DALI 35/220-240/700 NFC TW L and
OTi DALI 75/220-240/1A4 NFC TW L are in compliance with Directive
2014/53/EU. The full text of the EU declaration of conformity is
available at the following internet address: www.osram.com/
ot-indoor-ce. Frequency range: 13 553 – 13 567 kHz. Technical
support: www. osram. com, +49 (0)89-6213-6000. 1) Constant current
LED Power Supply; 2) t c point; 3) Connect PE to case or PIN 3; wire
preparation; push in; 4) Designed and engineered in Germany/Italy;
Made in Bulgaria by OSRAM 5) picture only for reference, valid print
on product; 6) Mains (PIN 1, PIN 2); 7) Input; 8) Output; 9) Year;
10) Week
2) 4)
OTI
35W
NFC NFC
TW L TW L
B16
30 x
B10
19 x
T 180 μs 210 μs
H
V AC
198 – 264 V
N
V DC 176 – 276 V
N
OTI
75W
20 x
13 x