Symbols On The Charger; Emptying And Cleaning The Product (Fig. D ); Maintenance - Black+Decker Dustbuster PSA115B Bedienungsanleitung

Symbols on the charger

Read all of this manual carefully
before using the appliance.
This tool is double insulated;
therefore no earth wire is
required. Always check that the
power supply corresponds to
$
the voltage on the rating plate.
The charging base is intended
for indoor use only.
Labels on appliance
The following symbols appear on this appliance along with the
date code:
Only use with charger N494249
N494249
Features
This tool includes some or all of the following features.
1. On/off power button
2. Sweeper head
3. Handle
3a. Hole for storage
4. Middle poles (x2)
5. Lower pole
6. Sweeper head pole
7. Dustbin
8. Dustbin release tabs
9. Cleaning tool
10. Charging dok
11. Storage magnet
Assembly (Fig. A)
Slide the lower pole ( 5 ) into the sweeper head pole ( 6 ).
u
Ensure the slot of the lower pole is on the top.
Slide one of the middle poles ( 4 ) into the lower pole.
u
Ensure the nub of the middle pole lines up with the slot of
the lower pole.
Slide the second middle pole into the first. Ensure the nub
u
of the second middle pole lines up with the slot of the first
middle pole.
Slide the handle ( 3 ) into the second middle pole ( 4 ).
u
Ensure the nub of the handle lines up with the slot of the
middle pole.
Charging the battery (Fig. B)
The battery will need to be charged for a minimum of 10
u
hours before first use to ensure full power.
(Original instructions)
Plug the jack plug of the charger ( 12 ) into the charging
u
dock ( 10 ) of the tool as shown in Figure B. Plug the
charger into a power outlet. The charging indicator will
be lit. While charging, the charger may get warm, this is
perfectly normal and safe. It is safe to leave the appli-
ance connected to the charger indefinitely. The charger
automatically reduces power consumption when charging
is complete.
When charging is complete, the LED will turn off.
u
Use
Switching on and off (Fig. C
To switch the appliance on, press and hold the on/off
u
switch (1) with your foot.
To switch the appliance off, depress the button again.
u
Emptying and cleaning the product (Fig. D
Hold the sweeper over a garbage can.
u
Simultaneously press both dust bin release tabs ( 8 ). The
u
door of the dust bin ( 7 ) underneath the sweeper head
( 2 ) will drop open, releasing the dust and dirt.
Close the dust bin door until the two release tabs click
u
into place.
Cleaning beater bars Fig. E
Turn the sweeper upside-down to expose the beater
u
brushes.
Use the comb side ( 13 ) of the cleaning tool ( 9 ) to pull
u
away any hair or debris.
If needed, use the blade side ( 14 ) of the cleaning tool to
u
cut away hair or debris for easier removal.
Note: Ensure all hair is removed from the areas shown in
figure E1.
Storage
Warning! Store the sweeper so that if the handle falls, it will
not strike a person, animal, or valuable.
To store, lift the back of the sweeper head ( 2 ) up until
u
the storage magnet ( 11 ) engages with the metal plate.
Place the plastic caps of the cleaning tool on either end
u
and snap the tool onto a pole.
The sweeper has a hole (3a) situated on the handle (3)
u
which is ideal for hanging the unit from a wall fitting.
Note: Always empty the unit before storing.

Maintenance

Your BLACK+DECKER corded/cordless appliance/tool has
been designed to operate over a long period of time with a
minimum of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
ENGLISH
)
)
5