Installation; Connection Diagram; Operation; Troubleshooting - Tripp Lite B006-004-R Benutzerhandbuch

Installation:

Before you begin, make sure that power to your computers and peripherals (monitor, scanner, etc.) is
turned off.
1. Connect your monitor to the Console Video Port on the switch
2. Connect your USB peripherals to the USB Downstream Ports on the switch. Make sure you have a USB
keyboard and mouse at the very least.
3. Use the video extension cable in 1•Tripp•Lite Cable Kit # P758-006 or P758-010 to connect the each
video port on the switch to the video port on the corresponding computer
4. Use the USB A-B cable in 1•Tripp•Lite Cable Kit # P758-006 or P758-010 to connect the each
Upstream Port on the Switch to available USB port on the corresponding computer
Note: The Switch defaults to Port 1 when powered-on. If the computer attached to Port 1 is inactive, the
monitor will be blank so it may appear as if the unit is not functioning. This is not the case. Simply press
the Port Selection Switch (on the front panel), to switch to an active computer on one of the other ports.

Connection Diagram

Operation

Note: Not all USB devices function well when connected to the additional downstream ports on the KVM
switch (the ports adjacent to the keyboard and mouse console ports). The drivers for some USB devices
must be un-initialized before the device is disconnected. Failure to do so may result in a system crash.
Switching computers with the Port Selection Switch is equivalent to disconnecting the device. Therefore, if
you are experiencing problems when switching ports, be sure that you un-initialize the drivers for these
USB devices before switching.
Manual Port Selection
Each port has a corresponding port selection button on the front panel. Press the Port Selection button on
the front panel to connect to the desired unit.
Auto Scan Mode
Automatically switches among the attached computers at regular intervals (3 or 15 seconds). Lets you
monitor the activity of each PC without having to switch the ports yourself. Press the Auto Scan button on
the front panel to invoke Auto Scan Mode. The Auto Scan LED flashes to indicate that the Auto Scan Mode
is enabled.
To turn Auto Scan Mode Off, press the Auto Scan button again. The Auto Scan LED will stop flashing
when Auto Scan Mode is no longer in effect.
Note: While Auto Scan Mode is in effect, neither the keyboard nor the mouse will function. You must turn
off Auto Scan Mode to be able to use the console.
Operation... Operation...

Troubleshooting

Insert Diagrams of front and back
Insert Connection Diagram