glass 1989 MYSPA 195 E Installations-, Bedienungs- & Wartungsanleitung Seite 19

AVOIDING THE RISK OF ELECTROCUTION
Risk of electrocution
exceed all national and local electrical codes.
WARNING:
NOTE: Failure to wait 30 seconds before resetting the GFCI
may cause the spa's Power Indicator (on the control panel)
to blink. If this occurs, repeat the GFCI test procedure.
compartment containing the electrical components.
DANGER: RISK OF ELECTRICAL SHOCK
installed within 1.5 m of a metal surface if each metal surface
is permanently connected solid copper conductor attached to
provided for this purpose.
to maintain a safe distance may result in death, or serious
fall into the spa.
electrical compartment and from all electrical components.
DO:
- use a licensed electrical contractor.
spa or servicing the electrical components.
DON'T:
motor damage.
ground system is therefore required, with sensitivity meeting
the relevant standards.
GROUNDWIRE.
to the electrical system.
EQUIPOTENTIAL CONNECTION.
found in the product.
SPA START-UP
preliminary checks on the system and make any adjustments.
CAUTIONS
limit thermostat may result.
to the spa automatically activates critical components
within the spa, such as controls, heater, circulation
pump and other systems. If power is supplied to these
will be damaged, and this may result in a non-warranty
component failure.
below are completed.
polyhexamethylene biguanide (Biguanide, PHMB)
sanitizer.
that the unions on either side of the pumpare hand-tight.
IMPORTANT: Manufacturer does not recommend that the
spa.
In any case the control panel will display the temperature of
IMPORTANT: Be sure that the air control valves are open by
turning each one counter-clockwise and checking to see that
all the diverters are in position 1 or position 3.
section.
19
EN
Mid-Position -Positioning the diverter at