Pre-Installation Requirements; Site Preparation - glass 1989 MYSPA 195 E Installations-, Bedienungs- & Wartungsanleitung

WARNING.
herein are not complied with.
existing standards of the installed country.
personnel.
Do not remove the sticker from the product!
Figure A
WARNING.
Read the manual carefully in all its parts before using the
product.
However the instructions remain unchanged.
manufacturer's name) are contained in the silver data plate
on the unit and on the warranty card. It is issued at the time
of testing.
clean, to avoid slips or falls entering or editing the product
itself.
appliance.
for an extended period.
All measurements are in mm.

PRE-INSTALLATION REQUIREMENTS

IMPORTANT: given the high capacity and weight of the
and building services engineering study is necessary.

SITE PREPARATION

Leveling Preparation section of this manual.)
electrical components, in a place where water will drain away
from it. Allowing water into the equipment compartment can
damage the electronics, or may result in tripping your house's
care and maintenance.
components or internal plumbing as a result of rodent
infestation is NOT covered under your warranty!
WARNING
Manufacturer recommends that the spa be installed above
ground. Lowering the top of the spa to ground level, or
employing decking which raises standing level toward
the top of the spa substantially increases the hazard of
accidental entry. Consult a licensed building contractor to
DECK INSTALLATION
structure's rated capacity, or serious structural damage could
result.
INDOOR/BASEMENT INSTALLATION
Be aware of some special requirements if you place your spa
materials must provide a good grip when wet. Proper drainage
on exposed wood, paper, etc. in the room. To minimize these
installed.
WARNING: Please keep the area around your spa well
To prevent the formation of condensation inside the space
minimum area of 314cm 2
of a higher-than-normal concentration of spa chemicals and/
compromised immune system or respiratory infection. If you or
as follows:
17
EN