AEG FAVORIT 35400 I Benutzerinformation Seite 26

26 www.aeg.com
2. Set the rinse aid dispenser to the
lowest position.
If you stop to use the combi
detergent tablets, before you
start to use separately
detergent, rinse aid and
dishwasher salt, do these
steps:
1. Turn the programme knob until the
programme marker is aligned with
the shortest programme with a rins-
ing phase.
2. Set the water softener to the highest
level.
3. Make sure that the salt container and
the rinse aid dispenser are full.
4. Start the set programme, without de-
tergent and without dishes.
5. Adjust the water softener to the wa-
ter hardness in your area.
6. Adjust the released quantity of rinse
aid.
6.3 Setting and starting a
programme
Setting mode
The appliance must be in setting
mode to start a programme.
• Turn the programme knob until the
programme marker is aligned with a
programme on the control panel. If
the on/off indicator comes on and the
phase indicators for the programme
start to flash, the appliance is in set-
ting mode.
• Turn the programme knob until the
programme marker is aligned with a
programme on the control panel. If
the on/off indicator and the start indi-
cator come on and a phase indicator is
on with fixed light, the appliance is not
in setting mode.
To put the appliance in setting mode,
press and hold the start button until the
start indicator goes off and the phase in-
dicators for the programme start to
flash.
Starting a programme without
delay start
1. Open the water tap.
2. Close the appliance door.
3. Turn the programme knob until the
programme marker is aligned with
the programme you want to set.
• The on/off indicator comes on.
• The phase indicators of the set
programme start to flash.
4. Press the start button. The pro-
gramme starts.
• The start indicator comes on.
• Only the indicator of the phase in
operation stays on.
Starting a programme with
delay start
1. Set the programme.
2. Press the delay button to delay the
start of the programme of 3 hours.
The delay indicator comes on.
3. Press the start button. The count-
down starts.
• The start indicator comes on.
• The phase indicators of the set
programme go off.
• When the countdown is completed,
the programme starts.
– The indicator of the phase in opera-
tion comes on.
Opening the door while the
appliance operates
If you open the door, the appliance
stops. When you close the door, the ap-
pliance continues from the point of inter-
ruption.
Cancelling the delay start
while the countdown operates
1. Press and hold the start button until
the start indicator and the delay indi-
cator go off.
• The phase indicators of the set
programme start to flash.
2. Press the start button. The pro-
gramme starts.