Setting And Starting Aprogramme; Setting Mode - AEG FAVORIT 65020 I Benutzerinformation

SETTING AND STARTING A
PROGRAMME

Setting mode

The appliance must be in setting mode to
accept some operations.
The appliance is in setting mode when,
after the activation:
• All the programme indicators come on.
• The display shows two horizontal status
bars.
If the control panel shows other condi-
tions, press and hold Delay and Start at
the same time until the appliance is in set-
ting mode.
Starting a programme without
delay start
1. Open the water tap.
2. Press the on/off button to activate the
appliance.
3. Close the appliance door.
4. Make sure that the appliance is in set-
ting mode.
5. Press Program again and again until
the indicator of the programme that
you want to set comes on.
• The programme duration flashes in
the display.
• The phase indicators of the set pro-
gramme come on.
6. If you want, you can set the options.
7. Press Start. The programme starts.
• Only the indicator of the phase in
operation stays on.
• The display shows the programme
duration that decreases with steps
of 1 minute.
Starting a programme with
delay start
1. Set the programme and the options.
2. Press Delay again and again until the
display shows the delay time you want
to set (from 1 to 24 hours).
• The delay time flashes in the dis-
play.
• The delay indicator is on.
3. Press Start. The countdown starts.
• The display shows the countdown of
the delay start that decreases with
steps of 1 hour.
• The phase indicators of the set pro-
gramme go off.
• When the countdown is completed, the
programme starts.
– The indicator of the phase in opera-
tion comes on.
Opening the door while the
appliance operates
If you open the door, the appliance stops.
When you close the door, the appliance
continues from the point of interruption.
Cancelling the delay start while
the countdown operates
Press Delay again and again until:
• The display shows the programme du-
ration.
• The phase indicators come on.
• The programme starts.
Cancelling the programme
Press and hold Delay and Start at the
same time until:
• All the programme indicators come on.
• The display shows 2 horizontal status
bars.
Make sure that there is detergent
in the detergent dispenser before
you start a new programme.
At the end of the programme
When the programme is completed, the
end indicator comes on and the display
shows 0.
1. Press the on/off button to deactivate
the appliance.
2. Close the water tap.
If you do not press the on/off but-
ton, the AUTO OFF device auto-
matically deactivates the appli-
ance after some minutes. This
helps to decrease the energy con-
sumption.
ENGLISH
33