Cleaning, Maintenance And Ordering Of Spare Parts; Waste Disposal - EINHELL MR 920 LCD Originalbetriebsanleitung

Anleitung_MR_920_LCD_SPK7:_
GB
LCD display.
Set the desired switch ON time with the button 4
or 5.
"AUTO ON" then shines with a steady light and
the set switch ON time is indicated. The appliance
switches on the heater after the set switch ON
time has elapsed.
The display switches to "AUTO OFF" and "10 HR".
The appliance switches off automatically after
10h.
As long as the heater is running you can set the
switch OFF time manually as described in section
6.1.3.
7.2 Programming examples
7.2.1 Automatic switch ON time
Set the automatic switch OFF time "AUTO OFF" to
3 hours (see 6.1.3).
Set the automatic switch ON time "AUTO ON" to 2
hours (see 6.1.4).
Result:
The appliance switches on the heater after 2 hours
have elapsed and switches off after a further 3 hours
in heating mode.
7.2.2 Automatic switch OFF time
Set the automatic switch OFF time "AUTO OFF" to
7 hours (see 6.1.3).
Result:
The appliance switches off after 7 hours have
elapsed.
7.2.3 Temperature indication in °C / °F
Press button 3 (F/C) to select between degrees
Celsius °C and degrees Fahrenheit °F for the
temperature indication in the LCD display. Press
button 3 repeatedly until the desired indication
appears.
8. Cleaning, maintenance and ordering
of spare parts
8.1 Cleaning
Before carrying out any cleaning and
maintenance work the equipment must be turned
off, disconnected from the power supply and
cooled down.
Use a damp cloth to clean the casing.
Remove dust pollution with a vacuum cleaner.
8.2 Servicing
12
14.06.2010 8:38 Uhr Seite 12
Maintenance and repair work may only be carried
out by an electrical servicing contractor or ISC
GmbH.
Check the mains lead at regular intervals for
signs of defects or damage. A damaged mains
lead may only be replaced by an electrician or
ISC GmbH in compliance with the relevant
regulations.
There are no parts inside the equipment which
require additional maintenance.
The ribs are filled with a special oil. Repairs that
necessitate the oil seal to be opened may only
be carried out by the customer service
responsible for your country. If oil leaks from the
appliance, return it to the customer service
responsible for your country for examination.
8.3. Ordering spare parts
Please provide the following information on all orders
for spare parts:
Model/type of the equipment
Article number of the equipment
ID number of the equipment
Part number of the required spare part
For our latest prices and information please go to
www.isc-gmbh.info
9. Storage
Store the equipment and accessories out of children's
reach in a dark and dry place at above freezing
temperature. The ideal storage temperature is
between 5 and 30 °C. Store the electric tool in its
original packaging.

10. Waste disposal

Defective devices must be disposed of properly.
Please contact the customer service center
responsible for your country.
Accessories and packaging should be disposed of in
an environment-friendly fashion, i.e. by taking them
to a recycling depot. Plastic parts are coded for
purposes of separation when recycling.
It is imperative to follow the applicable oil disposal
directives when the equipment is scrapped.