Vasner Teras 25 Bedienungsanleitung Seite 21

Component parts
(1) Appliance body
(2) Plastic shade
(3) Protective grid
(4) Carbon Infrared Heating Tube
(5) IR receiving unit of remote control
(6) LED display
(7) Function Button / Display / ON / OFF
(8) moveable mounting plates
6
7
Teras 25 quick installation
• Using the screws, screw both L-shaped metal brackets to the joint
grating on the U-shaped metal bracket
• Once you have determined the desired position, use the metal support
to draw drill holes on the wall or ceiling
• Now screw the metal supports with the L-shaped brackets to the brass
supports on the rear of the device. You can slide the supports on the
rear of the device to the required position
• To change the radiation angle, slightly loosen the joint screws and then
tighten them again. Only make any necessary adjustments when the
device is switched off
• The heater can be installed horizontally or vertically, and to the wall or
the ceiling
2
3
5, 6, 7
GB
VASNER
1
4
8
21